Icom ID-5100A - GPS Logger Function; DGPS Logger Operating Outline; DGPS Logger Operation; D Setting the GPS Record Interval

8
GPS OPERATION
8-38
The GPS Logger function allows you to store the posi-
tions from a GPS receiver into a SD card as a log.
The GPS Logger stores Latitude, Longitude, Altitude,
Positioning state, Course, Speed and Date.
If you use this GPS Logger while driving, you can check
your driving history on a mapping software.
D GPSLoggeroperatingoutline
To use GPS Logger function, perform following opera-
tions.
1.InsertaSDcard.
( SD cards are not available from Icom. Purchase lo-
cally.)
2.CheckwhetherornottheGPSreceiverisreceiv-
ingyourposition.(p. 8-2)
3.TurnONtheGPSLoggerfunction.

 Completed!TheGPSLoggerfunctionstarts.
NOTE:
• The GPS logger function requires an SD card.
• Once the GPS logger function is turned ON, the
transceiver continuously stores the position data
from the GPS receiver, even if the transceiver is re-
booted. To cancel this function, turn OFF the func-
tion.
While this function is ON, and when the transceiver
is turned OFF, the log file will be closed. Then the
transceiver is turned ON and Positioning is carried
out by the GPS receiver, a new log file will be cre-
ated.
• When the SD card is full, this function will be auto-
matically paused.
GPSLoggerfunction
D GPSLoggeroperation
Select whether or not store your route as a log.
When the GPS Logger function is ON, the transceiver
stores the position data from GPS receiver into SD card
in a specified time interval.
The stored GPS sentences are GGA, RMC, GSA and
VTG.
Touch [MENU]. q
Touch “GPS Logger.” w
(GPS > GPSLogger)
• If the item is not displayed, touch [∫] or [√] one or more
times to select another page.
Touch “GPS Logger.” e
Touch “ON.” r
Touch [MENU]. t
• Closes the Menu screen, and the GPS Logger function
starts.
D SettingtheGPSrecordinterval
For example, when you are walking and if the time in-
terval is set to “1sec,” a lot of position data is stored
at almost same place. Select the GPS Logger function
record interval to suit your travel speed. (Default: 5sec)
Touch [MENU]. q
Touch “Record Interval.” w
(GPS > GPS Logger > RecordInterval)
• If the item is not displayed, touch [∫] or [√] one or more
times to select another page.
Touch e a desired record interval.
• Selectable settings are 1, 5, 10, 30 or 60 seconds.
Touch [MENU]. r
• Closes the Menu screen.
Previous view