Icom ID-5100A

12
MENU SCREEN
12-59
Speed (Default:mph*)
Display > Display Unit > Speed
Select either the km/h, mph or knots format to display
the speed.
Temperature (Default:ºF*)
Display > Display Unit > Temperature
Select either the degrees ºC or ºF format to display the
temperature.
Barometric (Default:inHg*)
Display > Display Unit > Barometric
Select between the hPa, mb, mmHg and inHg format to
display the barometric pressure.
Rainfall (Default:inch*)
Display > Display Unit > Rainfall
Select either the mm or inch format to display the
amount of rainfall.
WindSpeed (Default:mph*)
Display > Display Unit > Wind Speed
Select between the m/s, mph and knots format to dis-
play the wind speed.
DisplayLanguage (Default:English)
Display > Display Language
This item appears only when the “System Language”
is set to “Japanese.”
See page 12-60 “Choose your language carefully”
about setting cautions.
Set the screen display language type in the DR screen
or Menu screen to English or Japanese.
SystemLanguage (Default:English)
Display > System Language
Set the system language of the transceiver to English
or Japanese.
• English: The system language of the transceiver is
English.
- Only alphabetical characters (A to Z, a to z, 0
to 9) and symbols (! " # $ % & ' ( ) * + , - . / : ;
< = > ? @ [ \ ] ^ _ ` { | } ~) can be displayed.
If Japanese characters (Kanji, Hiragana and
Katakana) are included, the LCD shows “=” or
“_” instead of that character. In this case, you
can only delete “=” or “_” in the transceiver's
edit mode.
- The Display Language item will be hidden.
• Japanese: The system language of the transceiver is
Japanese.
Kanji, Hiragana and Katakana characters,
and the 2-bytes symbols can be displayed
on the LCD.
To display such characters in the DR
screen or Menu mode, Display Language
must be set to “Japanese.”
Display items (Continued)
* The default value may differ, depending on the transceiver’s
version.
Previous view