1
PANEL DESCRIPTION
1-5
Controller — Display (Touch screen) (Continued)
Functionmenu D
You can toggle the function group to select the desired func-
tion keys to operate the transceiver, depending on the trans-
ceiver’s operating mode or status.
Each function key works for the MAIN band.
• In the VFO, Memory or Call channel mode, you can select
the F-1 to F-4 menus.
• In the DR screen, you can select the D-1 to D-3 menus.
Touch the group icon to toggle the function group. ➥
Touch the group icon for 1 second to display the ➥
function menu list.
q w e r t
q [V/M]
Touch to toggle between the VFO and Memory
modes.
w [CALL]
Touch to turn the Call channel mode ON or OFF.
e [MW]
Touch to open the Memory Write window. ➥
In the VFO mode or the DR screen, touch for 1 ➥
second to store the operating data into the blank
channel.
In the Memory or Call channel mode, touch for 1 ➥
second to open the Memory Edit screen.
r [SCAN]
Touch to open the Scan type setting window. ➥
Touch for 1 second to start the last used scan. ➥
t [MONI]
Touch to turn the Monitor function ON or OFF.
u i o !0y
y [SKIP]
(Appears in the Memory mode.)
Touch to open the Scan Skip setting window.
u [DTMF]
Touch to open the DTMF send window.
i [VOICE]
When you insert an SD card into the transceiver’s
SD card slot, touch to open the “VOICE TX” screen.
o [LOW]
Touch to open the TX power setting window.
!0 [GPS]
Touch to open the GPS item setting window.
!2 !3 !4 !5!1
!1 [DUP]
Touch to open the duplex direction setting window.
!2 [TONE]
(Displayed only when in the FM/FM-N mode.)
Touch to open a Tone function setting window.
!3 [REC]
When you insert an SD card into the transceiver’s
SD card slot, touch to start recording a QSO (com-
munication) audio.
!4 [SCOPE]
Touch to open the sweep item setting window.
!5 [ ≈]
( Displayed only when you select a sweep operation
in [SCOPE](!4).)
Touch to start a single sweeping. ➥
Touch for 1 second to start a continuous sweep- ➥
ing.
While sweeping, touch to stop it. ➥
!7 !8!6
(Displayed only when in the DV mode.)
!6 [RX>CS]
Touch to open the “RX>CS” screen. ➥
Touch for 1 second to set the received station call ➥
sign as the destination (UR) call sign.
!7 [CD]
Touch to open the “RX HISTORY” screen.
!8 [CS]
Touch to open the “CALL SIGN” screen.
!7 !8 !9 @0!6
!9 [SCAN]
Touch to open the DR scan setting window. ➥
Touch for 1 second to start the last used scan. ➥
@0 [MONI]
Touch to turn the Digital Monitor function ON or
OFF.
To Next Page
Loading...
Need help?
General
