Icom ID-5100A

12
MENU SCREEN
12-45
DigitalMonitor (Default:Auto)
DV Set > Digital Monitor
Select a receive mode when [MONI] on the function
menu is touched in the DV mode.
• Auto: Receives in the DV mode or the FM mode,
depending on the received signal.
• Digital: Receives in the DV mode.
• Analog: Receives in the FM mode.
DigitalRepeaterSet (Default:ON)
DV Set > Digital Repeater Set
Turn the digital repeater setting function ON or OFF.
In any DV mode except when using the DR function,
and when accessing a repeater that has a call sign that
is different than the transceiver’s setting, this function
reads the repeater’s signal and automatically sets the
repeater call sign in R1 and R2.
• OFF: Turns OFF the function.
• ON: Automatically sets the repeater call sign.
DV Auto Detect (Default:OFF)
DV Set > DV Auto Detect
Turn the DV mode automatic detect function ON or
OFF.
If you receive an FM signal in the DV mode, this func-
tion temporarily switches to the FM mode.
• OFF: Turns OFF the function. The operating mode is
fixed to the DV mode.
• ON: Automatically selects the FM mode for tempo-
rary operation.
RX Record (RPT) (Default:ALL)
DV Set > RX Record (RPT)
The transceiver can record the data of up to 50 indi-
vidual calls.
When the received signal includes a status message
(“UR?” or “RPT?”) that is sent back from the access
repeater, you can record up to 50 messages, or only
the last call, in the Received Call Record.
• ALL: Records up to 50 calls.
• Latest Only: Records only the last call.
BK (Default:OFF)
DV Set > BK
The BK (Break-in) function allows you to break into a
conversation, where the two other stations are commu-
nicating with call sign squelch enabled.
• OFF: Turns OFF the function.
• ON: Turns ON the function.
NOTE:The BK function is automatically turned OFF
when transceiver is turned OFF.
EMR (Default:OFF)
DV Set > EMR
The EMR communication function can be used in the
digital mode. With the EMR function, no call sign setting
is necessary.
When you transmit a call with the EMR function, all
transceivers that receive an EMR signal automatically
open their squelch to receive the signal.
When an EMR signal is received, the audio (voice) will
be heard at the specified level, even if the volume is set
to a minimum level, or digital call sign or digital code
squelch is in use.
• OFF: Turns OFF the function.
• ON: Turns the function ON.
NOTE: The EMR function is automatically turned
OFF when transceiver is turned OFF.
EMR AF Level (Default:19)
DV Set > EMR AF Level
Set the audio output level to between 0 and 32 for when
an EMR communication signal is received.
When an EMR signal is received, the audio will be
heard at the set level, or the [VOL] control level, which-
ever is higher.
To disable the setting, set it to “0.”
NOTE:After an EMR signal disappears, the audio
level will remain at the EMR level. In this case, rotate
[VOL] to adjust the audio to a desired level.
DV Set items (Continued)
Previous view