4
SCAN OPERATION
4-13
!2 Enter a lower frequency. (Example: 118000)
• Touch [] to move the cursor backwards, or touch [] to
move the cursor forwards.
• Touch [CE] to clear the entered number.
• After entering a MHz digit, touch [Ω ≈] to automatically
enter ‘000.’
- Some frequencies cannot be entered.
!3 After entering a lower frequency, touch [Ω ≈].
• The cursor moves to a MHz digit of the higher frequen-
cy.
!4 Enter a higher frequency, and then touch [ENT].
(Example: 136000)
!5 Touch “TS.”
!6 Touch the desired tuning step to be used while pro-
gram scanning.
!7 Touch “MODE.”
• Displays the selectable mode.
!8 Touch the desired receive mode to be used while
program scanning.
• When you select “---,” the receive mode set in the VFO
mode is used during a scan.
!9 Touch [Z].
@0 Touch “<<Write>>.”
@1 Touch [YES].
• Displays the entered content in the “???” screen.
Tuning stepScan name
Receive mode
Entering scan edges (Continued)
To Next Page
Loading...
