EasyManua.ls Logo

Icom ID-52A

Icom ID-52A
263 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
GPS OPERATION (ADVANCED)
6-17
DWeather station transmission
When you transmit as a weather station, you should
set the weather station’s settings and input the
weather data into the [USB] port�
You can input the weather data from a third party’s
weather device by converting it to the APRS weather
format in your PC or microcomputer
After completing the weather station’s settings and
inputting the weather data, you can transmit as a
weather station�
NOTE: To input the Weather data into the [USB]
port, set “USB Connect” to “Serialport,” and set “USB
Serialport function” to “DV Data�”
([MENU] > SET > Function > USB Connect)
([MENU] > SET > Function > USB Serialport function)
If the weather data is not input into the [USB] port,
you cannot transmit as a weather station�
Weather
device
Microcomputer
PC
USB cable
(User supplied)
or
To the [USB]
port
DApplication setting
Configure the communication software as follows�
Port: The COM port number that is used by the
transceiver�*
Baud rate: Your desired speed
Data: 8 bit
Parity: none
Start: 1 bit
Stop: 1 bit
Flow control: none
* Depending on the PC environment, the COM port number
used by the ID-52A/E may be higher than 5�
In that case, use an application that can set it to higher
than 5�
Transmitting D-PRS data
DConfirming the weather data input
You can confirm whether or not the weather data is
input into the [USB] port�
1� Set “GPS TX Mode” to “D-PRS,” and “TX format”
to “Weather�” (p� 6-16)
2� On the Standby screen, push [QUICK]�
3� Select “Weather Information�”
L Displays the WEATHER INFORMATION screen if the
weather data is entered correctly
L When the weather information is displayed, you can
transmit as a weather station� If “-” is displayed on the
screen, the weather data is not entered� In that case,
check the entered data settings�
DAbout the weather data content
The weather data should be input according to the
format (based on the APRS
®
Weather Data), shown
below
Example:
220/004 g005 t077 r000 p000 P000 h50 b09900 End code
1 2 3 4 5 6 7 8 9
No. Item Value Unit
1 Wind direction 000 to 360 °
2 Wind speed 000 to 999 mph
3 Gust speed g000 to g999 mph
4
Temperature t-99 to t-01,
t000 to t999
°F
5 Rainfall r000 to r999*
1
inch
6 Rainfall (24 Hours) p000 to p999*
1
inch
7 Rainfall (Midnight) P000 to P999*
1
inch
8
Humidity h00, h01 to h99
(h00 indicates 100%�)
%
9
Barometric pressure b00000 to b99999*
2
hPa,
mb
*
1
The last two digits indicate the one decimal place and the
two decimal places�
*
2
The last digit indicates the one decimal place�
L If you have no data, enter a space or “�” (period) instead
of a number
(Example: “���/���g���t077r000p���P���h50b�����”)
L Enter <CR>, <LF>, or <CR><LF> for an end code�

Table of Contents

Other manuals for Icom ID-52A

Related product manuals