Icom ID-52A

5
D-STAR OPERATION (ADVANCED)
5-30
Repeater list
You can save repeater information for quick and
simple communication in up to 2500 repeaters
(repeater list) in up to 50 Groups�
Data must be in the repeater list to use the DR
function�
You can add and edit repeater content and groups in
the repeater list�
You can enter 4 types of frequencies into the repeater
list, as shown below:
• DV Repeater
• DV Simplex
• FM Repeater
• FM Simplex
TIP:
• For easy operation, the repeater list is preloaded
into your transceiver� However, if you do an
All Reset, the CPU deletes all setting data, the
Memory channels, and the repeater list� We
recommend that you back up the memory data to
a microSD card or save it to a PC using the CS-52
�
• The repeater list can be downloaded from the Icom
website� See “Updating the repeater list” that can
be downloaded from the Icom website about how
to update the repeater list using a microSD card�
https://www.icomjapan.com/support/
DRepeater list contents
The following contents are included in the repeater list:
• TYPE: Communication type (p� 5-32)
• NAME: Repeater name (p� 5-32)
• SUB NAME: Repeater sub name (p� 5-32)
• CALL SIGN: Repeater call sign and port letter
(p� 5-32)
• GW CALL SIGN: Gateway repeater’s call sign and port “G”
(p� 5-32)
• GROUP: Repeater group (p� 5-33)
• USE (FROM): access repeater use (p� 5-33)
• FREQUENCY: access repeater’s frequency (p� 5-33)
• DUP: Duplex direction (p� 5-33)
• OFFSET FREQ: Frequency offset (p� 5-33)
• MODE: Operating mode (p� 5-34)
• TONE: Tone setting (p� 5-34)
• REPEATER TONE: Repeater tone (p� 5-34)
• POSITION: Position data accuracy level (p� 5-34)
• LATITUDE: Latitude of the repeater (p� 5-34)
• LONGITUDE: Longitude of the repeater (p� 5-35)
• UTC OFFSET: UTC Offset (p� 5-35)
Example: “Hirano” repeater information