Icom ID-52A

7
VOICE TX FUNCTION
7-2
The Voice TX function transmits the recorded audio
that is on the microSD card, one time or repeatedly,
for up to 10 minutes at the set interval�
This function is convenient to repeatedly call CQ, or
for other events�
You can assign the [Voice TX] key function to an
optional microphone key or optional Bluetooth
headset� (pp� 12-18, 12-34)
NOTE: BE SURE to insert a microSD card into the
transceiver�
Voice TX function
DRecording the voice audio
[MENU] > VOICE > Record
1� Push [MENU]�
2� Select “VOICE�”
3� Select “Record�”
4� Hold down [PTT] to record�
L Information
• Hold the microphone 5 ~ 10 cm (2 ~ 4 inches) from
your mouth, then speak at your normal voice level�
• The maximum record time is 1 minute�
• Only 1 voice memory can be recorded�
TIP: On the VOICE TX RECORD screen,
push [QUICK], then select “Clear” to clear the
recorded audio�
5� Push [ENT] to confirm the recorded voice�
• The voice is played back�
Audio level
Recording time
L If you hold down [PTT], the recording starts again�
In this case, the previous recorded audio will be
overwritten�
L To exit the MENU screen, push [MENU]�
Displayed
while playing
Play back time
Total time
Displayed
while
recording