Icom ID-52A

5
D-STAR OPERATION (ADVANCED)
5-15
Connecting to a reflector
DLinking to a reflector
If your repeater is not currently linked to a reflector, or
if you want to change it to another reflector, follow the
steps below� Before linking to another reflector, BE
SURE to unlink the current reflector� (p� 5-14)
Direct inputting a reflector
Example: Directly enter “REF030CL�”
1� Push D-pad() to select “TO,” and then push [ENT]�
2� Select “Reflector�”
3� Select “Link to Reflector�”
4� Select “Direct Input�”
5� Push D-pad to move the cursor, and select the
reflector type, reflector number, or module letter�
6� Push [ENT]�
• Returns to the DR screen, and “Link to Reflector” and
“REF030CL” are displayed in “TO�”
7� Hold down [PTT] to link to the Reflector�
Using TX History
TX History saves up to 5 reflectors that your access
repeater linked to before�
Example: Select “REF030CL” in TX History�
1� Push D-pad(
 ) to select “TO” then push [ENT]�
• The TO SELECT screen is displayed�
2� Select “Reflector�”
The REFLECTOR screen is displayed�
3� Select “Link to Reflector�”
The Link to Reflector screen is displayed�
4� Select the Reflector that you want to link to�
• Returns to the DR screen, and “Link to Reflector” and
“REF030CL” are displayed in “TO�”
5� Hold down [PTT] to link to the Reflector�