4
FM RADIO OPERATION
4-4
Basic operation
DSearching for an FM Radio signal
While in the Tuning mode, hold down D-pad() to
start searching the broadcast signal�
DUsing the Attenuator function
The Attenuator prevents a desired signal from
becoming distorted when a very strong FM Radio
signal is near the frequency, or when a very strong
electric field, such as from a broadcasting station, is
near your location�
1� Push [QUICK]�
2� Select “ATT�”
3� Select “ON�”
• “ATT” is displayed�
Displayed when
the Attenuator is ON�
While searching, the frequencies are
sequentially displayed�
When a signal is received
• When you hold down D-pad(), a down scan starts, and
when you hold down D-pad(), an up scan starts�
• When a signal is received, the scan stops on the
frequency�
• To cancel the scan, push D-pad() or [CLR]�
To Next Page
Loading...
