Icom ID-52A

9
MEMORY OPERATION
9-4
Entering Memory channel contents
After selecting a frequency in the VFO mode, you can
enter it into a selected channel or an automatically
selected blank channel�
DEntering into a selected channel
Example: Entering 146�030 MHz/FM mode into
Channel 11 in Group 01�
1� Push [VFO/MHz] to enter the VFO mode�
2� Push [MODE] to enter the FM mode�
3� Rotate [DIAL] to set a frequency to 146�030 MHz�
4� Hold down [MW] for 1 second�
• A short and a long beep sound�
5� Select “Write to New CH�”
6� Push [QUICK]�
7� Select “Group Select�”
8� Select Group “01�”
9� Rotate [DIAL] to select Channel “11�”
10� Push [ENT]�
• The confirmation dialog is displayed�
11� Select “YES�”
• Beeps sound and the Memory contents are briefly
displayed, then returns to the VFO mode�
TIP: In step 7, you can select the following options�
• NAME:
Displays the Memory name edit screen� (p� 9-11)
• SKIP:
Displays the SKIP setting items�
• Group Select:
Displays the GROUP SELECT screen�
• <<Write>>:
Enters into the selected Memory channel�
• <<Insert Write>>:
Inserts a Memory channel above the selected
channel�