Icom ID-52A

10
SCAN OPERATION
10-5
1� Push [VFO/MHz] to enter the VFO mode�
2� Push [MODE] to select the operating mode�
3� Hold down [SCAN] for 1 second�
• Opens the Scan Type Select window�
4� Select a scan type�
Blinks
• The scan starts�
• The decimal point and the selected Scan Type icon
blink�
L When receiving a signal, the S-meter displays the
received signal strength�
5� Hold down [SCAN] for 1 second�
• Cancels the scan�
L Pushing [CLR] also cancels the scan�
DScan Type
• ALL: Full scan
• BAND: Band scan
• DUP: Duplex scan
(Displayed only when Duplex is set)
• P-LINK0 ~ 9: Program Link scan
• P00 ~ 24: Program scan
• TONE: Tone scan
(For the Tone Squelch scanning)
L Information
• The frequencies that are set as a Skip channel
(PSKIP) are skipped during a scan� (p� 10-6)
• When “Program Skip” is set to “OFF,” the Skip channel
frequencies are not skipped� (p� 12-5)
([MENU] > SET > Scan > Program Skip)
• To set a Program Link scan, see page 10-8�
• To set a Program scan, see page 10-7�
TIP:
• During a scan, rotate [DIAL] to change the scanning
direction�
• During a scan, push [MODE] to select the operating
mode�
• During a scan, hold down [
] to turn the Lock
function ON or OFF�
• The scan continuously runs, even if you push [MENU]
or [QUICK] during a scan�
• You can select a scan type by rotating [DIAL] while
holding down [SCAN]� Release [SCAN] to start the
scan�
VFO Scan