Icom ID-52A

15
OTHER FUNCTIONS
15-11
VOX function
DUsing the VOX function
[MENU] > SET > Function > VOX > VOX
1� Push [MENU]�
2� Select “Function” in the “SET” menu�
3� Select “VOX�”
4� Select “VOX�”
5� Select “ON�”
6� To exit the MENU screen, push [MENU]�
• When you connect the HS-94, HS-95, or HS-97
headset, “VOX” is displayed on the standby screen�
NOTE: While receiving a signal, or sounding a beep,
the transceiver does not switch to transmit by your
voice�
DSetting the VOX level
NOTE: We recommend you set the Microphone
Gain level to 3, before setting the VOX level�
([MENU] > SET > Function > MIC Gain (External))
[MENU] > SET > Function > VOX > VOX Level
1� Push [MENU]�
2� Select “Function” in the “SET” menu�
3� Select “VOX�”
4� Select “VOX Level�”
5� While speaking into the microphone, rotate [DIAL]
to adjust the VOX level�
• Displays “VOX” when the TX level audio is input�
L The VOX level can be adjusted between 1 (minimum)
and 10 (maximum), or turned OFF� (Default: 5)
L Higher values make the VOX function more sensitive
to your voice�
6� To exit the MENU screen, push [MENU]�
L If the S-meter does not display the output power
level, and the transceiver does not transmit, adjust
the VOX delay time�
([MENU] > SET > Function > VOX > VOX Delay)
L When the VOX function is ON, you can adjust the
VOX level by rotating [DIAL] while transmitting�