Icom ID-52A

5
D-STAR OPERATION (ADVANCED)
5-44
Are your settings correct?
If you make a Local Area call with a gateway repeater
still selected in “TO,” the destination repeater will be
busy while you transmit�
The stations that want to use the repeater as their
access repeater cannot access it, as shown below�
BE SURE to set CQCQCQ in “TO” on the DR screen
when you intend to make a Local Area call or finish a
Gateway call�
Example: JA3YUA wants to make a Local Area call�
CQ D-STAR Hirano, this is JA3YUA
through JP3YHH port A for a local call���
CQ D-STAR Hirano, this is JA3YUA
through JP3YHH port A for a local call���
CQ D-STAR Hirano, this is
JA3YUA through JP3YHH port A
for a local call���
CQ D-STAR Hirano, this is
JA3YUA through JP3YHH port A
for a local call���
CQ D-STAR Hirano, this is
JA3YUA through JP3YHH port A
for a local call���
CQ D-STAR Hirano, this is
JA3YUA through JP3YHH port A
for a local call���
INTERNETINTERNET
His setting is wrong!
I can’t access the repeater!
His setting is wrong!
I can’t access the repeater!
JA3YUA’s setting
The destination (“TO”) setting is incorrect�
Correct setting
To make a Local Area call, set the destination (“TO”)
to “CQCQCQ�” See page 5-9 for details�
NOTE: With this setting, you can make a Local Area
call, but the destination Repeater, selected in “TO,”
is also busy while you transmit�
The stations that want to use the repeater as their
Access Repeater cannot access it�
Caller
(JA3YUA)
Hirano area Hamacho area
Called