Icom ID-52A

8
RECORDER FUNCTION
8-2
NOTE:
• You must insert a microSD card into the transceiver
before recording audio�
• The recording function is continuously ON, even if the
transceiver is turned OFF then ON again�
Recording a QSO audio
To start recording
1� Push [QUICK]�
2� Select “<<REC Start>>�”
• “Recording started�” is displayed, then returns to the
standby screen�
To stop recording
1� Push [QUICK]�
2� Select “<<REC Stop>>�”
Recording standby
The recording starts when you
transmit or the squelch opens�
While recording, the SD card icon
blinks�
L Information
• The recording pauses while no signal is received, and
resumes when a signal is received again�
• The recording continues until you manually stop
recording, or the card becomes full�
• If the recording file’s content reaches 2GB, the
transceiver automatically creates a new file, and
continues recording�
TIP:
• You can select to record the received audio from
only the MAIN band or both the MAIN and SUB
bands� (p� 8-15)
( [MENU] > RECORD > QSO Recorder
> Recorder Set > REC Operation)
• When “RX REC Condition” is set to “Always,” the
recording automatically starts when
“<<REC Start>>” is selected� In that case,
recording continues, even when no signal is
received�* (p� 8-15)
( [MENU] > RECORD > QSO Recorder
> Recorder Set > RX REC Condition)
* The recorded file contains no sound�