12
SET MODE
12-32
Bluetooth Set
Bluetooth (Default: OFF)
[MENU] > SET > Bluetooth Set > Bluetooth
Turns the Bluetooth function ON or OFF�
Auto Connect (Default: ON)
[MENU] > SET > Bluetooth Set > Auto Connect
Selects whether or not to automatically connect to the
paired Bluetooth device when its power is turned ON�
• OFF: Does not connect to the paired device�
• ON: Automatically connects to the last connected
device�
Pairing/Connect
[MENU] > SET > Bluetooth Set > Pairing/Connect
Searches for the Bluetooth device to connect, or
display the paired Bluetooth devices in the list�
L See page 13-3 for details�
<<Pairing Reception>>
[MENU] > SET > Bluetooth Set > <<Pairing Reception>>
Enters the pairing reception mode�
L See page 17-7 for details�
AF Output (Default: Headset Only)
[MENU] > SET > Bluetooth Set > Headset Set >
AF Output
Selects the AF Output device when a Bluetooth
headset is connected�
• Headset Only: Outputs audio to only the connected
Bluetooth headset�
• Headset & Speaker:
Outputs audio to both the connected
Bluetooth headset and the
transceiver’s speaker�
Headset Function Select (Default: Normal)
[MENU] > SET > Bluetooth Set > Headset Set >
Headset Function Select
Selects the PTT and microphone combination when
both the Bluetooth headset and the transceiver
microphone are used�
• Normal: Transmits the audio from the Bluetooth
headset, or the transceiver microphone,
whichever [PTT] is pushed�
• Microphone:
Transmits the audio from the Bluetooth
headset�
Transmission is enabled by pushing either
the [PTT] on the Bluetooth headset, or the
transceiver microphone� The transceiver
microphone is only used for the PTT
control�
• PTT: Transmits the audio from the transceiver
microphone�
Transmission is enabled by pushing either
the [PTT] on the Bluetooth headset, or the
transceiver microphone� The Bluetooth
headset is only used for the PTT control�
L The Bluetooth headset operation for each option is listed
below�
Option TX control TX audio
Normal Enabled Enabled
Microphone Enabled Enabled
PTT Enabled
Disabled
( Audio from the microphone is
transmitted�)
Auto Disconnect (Default: OFF)
[MENU] > SET > Bluetooth Set > Headset Set >
Auto Disconnect
Sets the Disconnect Timer between 0 and 10
seconds, or OFF�
If there is no audio output from the Bluetooth headset,
and there is no key operation for this set period of
time, the Synchronous Connection-Oriented (SCO)
link* is automatically disconnected�
L The SCO link is connected when the signal is received, a
beep sounds, or there is a key operation�
* A Bluetooth link for voice communication
To Next Page
Loading...
