5
D-STAR OPERATION (ADVANCED)
5-4
“FROM” (access repeater) setting
When your access repeater is in your transceiver’s
repeater list, you can select it from the list� By just
selecting the repeater from the list, the repeater call
sign, its frequency, duplex setting, and frequency
offset are automatically set, for easy operation�
Example: Selecting the “Kirkland (IA)” repeater in
Washington state in the USA from the
repeater list�
1� Hold down [DR] for 1 second to display the DR
screen�
2� Push D-pad() to select “FROM,” and then push
[ENT]�
3� Select “Repeater List�”
4� Select the repeater group where your access
repeater is listed�
TIP:
When you select an FM repeater:
When an FM repeater is in your transceiver’s
repeater list, you can select it from the list�
When selecting an FM repeater, the “TO” setting is
not necessary, and a “––––” is displayed in “TO�”
When selecting an FM repeater�
How to change the repeater group:
To change the repeater group on the DR screen,
push [QUICK], then select “Group Select�”
5� Select your access repeater�
• Returns to the DR screen, and the selected repeater
name is displayed in “FROM�”
L The repeater list, described in this manual, may differ
from your transceiver’s preloaded contents�
DUsing your transceiver’s repeater list
To Next Page
Loading...
