Icom ID-52A - Dtransmitting the Recorded Voice Audio

7
VOICE TX FUNCTION
7-3
Voice TX function
NOTE: BE SURE to insert a microSD card into the
transceiver�
[MENU] > VOICE > <<Single TX>>
[MENU] > VOICE > <<Repeat TX>>
1� Push [MENU]�
2� Select “VOICE�”
3� Select “<<Single TX>>” or “<<Repeat TX>>�”
• <<Single TX>>:
The recorded voice audio is transmitted only once�
• <<Repeat TX>>:
The recorded voice audio is repeatedly transmitted�
L Information
• While transmitting, the SD card icon blinks�
• When you select “<<Repeat TX>>,” the transceiver
repeatedly transmits the recorded voice audio for up to 10
minutes at the interval set in “Repeat Time�”
([MENU] > VOICE > TX Set > Repeat Time)
• Any of the following action cancels the transmission�
- Pushing [PTT]
- Turning OFF the transceiver, then turning it ON again�
- Pushing any key (except for [VOL] and [
])
• After the second transmission, the transmission continues
pausing, if receiving a signal, even if “Busy Lockout” is set
to “ON�”
([MENU] > SET > Function > Busy Lockout)
However, if the squelch is manually opened in the
FM mode, the voice audio is repeatedly transmitted,
according to the “Repeat Time” setting�
• You can select whether or not to output the TX voice
audio from the speaker�
([MENU] > VOICE > TX Set > TX Monitor)
TIP: To transmit the recorded voice audio in the
Quick Menu window, push [QUICK], then select
“Voice TX�”
DTransmitting the recorded voice audio
Blinks
Transmission is
paused