Icom ID-52A

5
D-STAR OPERATION (ADVANCED)
5-31
Entering new information into the repeater list
This section describes how to manually enter new
repeater information into the repeater list�
The required setting items differ, depending on your
communication usage� Confirm the required items, as
shown below�
NOTE: To enter repeater information into the
repeater list, the repeater’s call sign must be entered
first�
DRequired items for the communication cases
Repeater list
contents
Used as an access
repeater
Used as a
destination repeater
Used as an FM
repeater
Simplex (FROM)
TYPE DV Repeater DV Repeater FM Repeater DV Simplex FM Simplex
NAME
    
SUB NAME
    
CALL SIGN
  
N/A N/A
GW CALL SIGN

(For a Gateway call)

N/A N/A N/A
GROUP
    
USE(FROM)
    
FREQUENCY
    
DUP
  
N/A N/A
OFFSET FREQ
  
N/A N/A
MODE N/A N/A

N/A

TONE N/A N/A

N/A

REPEATER
TONE
N/A N/A

N/A

POSITION
    
LATITUDE
    
LONGITUDE
    
UTC OFFSET
    

: Must be entered

: Possible to enter
N/A: Not Applicable