10
SCAN OPERATION
10-6
DStoring the skip frequencies
You can skip unnecessary frequencies during a scan�
While a scan is paused and if you want to skip the
frequency, you can store it into the Skip channels
group S (00 ~ 99) as a Skip channel (PSKIP)�
The Scan Skip function speeds up a scan�
1� While a VFO scan is paused, hold down [MW] for
1 second�
• The window, as shown above, is displayed�
2� Select “Adds to SKIP MR Group�”
• Two short beeps sound�
• The frequency is stored in the Skip channels group�
• After storing, the scan resumes�
L If there is no blank channel, an error beep sounds,
and the frequency is not stored�
TIP: Once a frequency is set as a Skip channel, the
frequency is skipped until you clear the skip setting�
To clear the skip setting, see page 10-11�
L The skip setting is also cleared when the Memory
channel set as a Skip channel is cleared�
VFO Scan
DAbout a Program scan name
When a Scan name is entered to a Program scan, the
name is displayed in the Scan Type Select window�
(p� 10-5)
L The name is not displayed during a scan�
L To enter the name, see page 10-7�
When the Scan name is entered
When the Scan name is not entered
DAbout a Program Link scan name
When a Program Link scan name is entered, it is
displayed in the Scan Type Select window�
(p� 10-5)
L The name is not displayed during a scan�
L To enter the name, see page 10-8�
When a Program Link name is entered
When a Program Link name is not entered
To Next Page
Loading...
