9
MEMORY OPERATION
9-5
Entering Memory channel contents
DOverwriting to the selected channel
You can write a frequency into a pre-entered channel�
Example: Entering 146�330 MHz/FM mode into
Channel 11 in Group 01�
1� Push [MR] to enter the Memory mode�
L For only the ID-52A, pushing [MR] each time selects
the Memory and Weather Channel modes�
2� Rotate [DIAL] to select Channel 11 in Group 01�
L To select a Memory Group, push [QUICK], and then
select “Group Select�”
3� Push [VFO/MHz] to enter the VFO mode�
4� Rotate [DIAL] to set a frequency to 146�330 MHz�
5� Hold down [MW] for 1 second�
• A short and a long beep sound�
6� Select “Write to Selected CH�”
7� Push [MR]�
8� Select “YES�”
• Beeps sound and the Memory contents are briefly
displayed, then returns to the VFO mode�
DEntering to a blank channel
Example: Entering 441�100 MHz/FM mode into a
blank channel�
1� Push [VFO/MHz] to enter the VFO mode�
2� Push [MODE] to enter the FM mode�
3� Rotate [DIAL] to set a frequency to 441�100 MHz�
4� Hold down [MW] for 3 seconds�
• The Memory contents are briefly displayed for 2
seconds, then returns to the VFO mode�
To Next Page
Loading...
