Icom ID-52A

10
SCAN OPERATION
10-9
Memory Scan
DScan Type
• ALL: Full scan
• BAND: Band scan
• MODE: MODE scan
• DUP: Duplex scan
(Displayed only when Duplex is set)
• GROUP LINK: Group Link scan
• GROUP 00 ~ 99: Group scan
• TONE: Tone scan
(For the Tone Squelch scanning)
L When 2 or more Memory channels that are not set as
Skip channels are entered, the Memory scan is usable�
L The channel set as a Skip channel (PSKIP or SKIP) is
skipped during a scan� (p� 10-11)
TIP:
• During a scan, rotate [DIAL] to change the scanning
direction�
• During a scan, hold down [
] to turn the Lock
function ON or OFF�
• The scan continuously runs, even if you push [MENU]
or [QUICK] during a scan�
• You can select a scan type by rotating [DIAL] while
holding down [SCAN]� Release [SCAN] to start the
scan�
NOTE: You must enter 2 or more Memory channels
that are not set as Skip channels to start a Memory
scan�
1� Push [MR] to enter the Memory mode�
L For only the ID-52A, pushing [MR] each time selects
the Memory and Weather Channel modes�
2� Hold down [SCAN] for 1 second�
• Opens the Scan Type Select window�
3� Select a scan type�
Blinks
• The scan starts�
• The decimal point and “
” blink�
L When receiving a signal, the S-meter displays the
received signal strength�
4� Hold down [SCAN] for 1 second�
• Cancels the scan�
L Pushing [CLR] also cancels the scan�