Icom ID-52A

10
SCAN OPERATION
10-7
8� After editing contents, select “<<Write>>�”
• The confirmation dialog is displayed�
9� Select “Yes�”
L To exit the MENU screen, push [MENU]�
TIP:
• To clear the Program scan range, select “Clear” in step 6�
• When scanning a range where the set “TS” or “MODE”
cannot be used, the preset “TS” or “MODE” setting on
each band is applied�
VFO Scan
DEntering Program Scan Edges
You can enter the upper and lower frequency edges
for a Program scan�
Each Program Scan range has its tuning step and
operating mode setting�
You can enter up to 25 Program Scan ranges (P-Scan
Edge) on the MENU screen�
[MENU] > SET > Scan > P-Scan Edge
1� Push [MENU]�
2� Select “Scan” in the “SET” menu�
3� Select “P-Scan Edge�”
4� Select a blank Program scan range “00” ~”24�”
L DO NOT push [ENT]�
5� Push [QUICK]�
6� Select “Edit�”
• The edit screen is displayed�
7� Select “FREQ LOW” or “FREQ HIGH” to enter the
lower edge and higher edge, and then push [ENT]�
L Information
• Rotate [DIAL] to select the item, and push [ENT] to
enter the edit screen�
• Set the lower edge and higher edge by rotating
[DIAL]�
Push [VFO/MHz] to select the 1 MHz tuning step�
• When the “NAME” is entered, it displays on the Scan
Type Select window�
See page iii on how to enter characters�
• When the “TS” (Tuning Step) and/or “MODE” is
blanked, they have used the current setting on the
VFO mode�
The “TS” and “MODE” must be set to match with your
desired signals�