Icom ID-52A

INTRODUCTION
iii
ENTERING AND EDITING TEXT
Controls used for text entry To change the character type
1. When not selecting text, or an entered text is
selected, push [QUICK].
2. Rotate [DIAL] to select the character type, and
then push [ENT].
Character
type
Selectable characters and
symbols
Character
conversion
ABC A to Z, 0 to 9, (space) A/a
abc a to z, 0 to 9, (space) A/a
123 0 to 9, (space) –
!”#
! “ # $ % & ’ ( ) * + , - . / : ; < = >
? @ [ \ ] ^ _ ` { | } ˜ (space)
–
TIP: When the character type is “ABC” or “abc,” and
while entering a character, push [QUICK] to select
upper case or lower case letters.
Push [QUICK]
• To insert a text, move the cursor to a place to enter,
and then rotate [DIAL] or push D-pad().
• To clear a character, push [CLR].
• To consecutively clear characters, continuously
hold down [CLR].
[DIAL] (Rotate)
Selects a character
[ENT]
Sets
Moves the cursor
to the left
Moves the cursor to
the right
Cancels Clears
Opens the
character
Opens the Entry
Select window
Selects the character