12
SET MODE
12-8
Call Sign
Call Sign
[MENU] > SET > Call Sign
Set or view the “UR,” “R1,” “R2,” and “MY” call signs
to use in the DV mode�
When not using the DR function, sets the call signs on
this screen�
For Simplex operation (DV mode)
You can set the “UR” and “MY” call signs�
For Duplex (repeater) operation
(DV mode/DR function)
You can set only the “MY” call sign when the DR
function is ON�
<To manually set the Duplex (repeater) operation>
Example: Making a gateway CQ call to Kirkland
repeater (N71H B) from the Hirano repeater
(JP3YHH A), in the DV mode�
L Before starting to set the call sign, set the frequency of
your Access repeater and duplex direction on the standby
screen�
TIP: When the Digital Repeater Set function is ON,
the repeater call sign is automatically set�
([MENU] > SET > DV Set > Digital Repeater Set)
Step 1. Setting the call sign “R1”
1� Select “R1�”
L DO NOT push [ENT]�
2� Push [QUICK]�
3� Select “Edit�”
4� Rotate [DIAL] to enter the first character�
L Selectable characters are alphanumeric characters
and symbol (“/”)�
5� Push D-pad () to move the cursor�
6� Repeat steps 4 and 5 to enter the repeater call
sign of up to 8 characters, including a space�
(Example: JP3YHH A)
7� After entering, push [ENT]�
• Saves the entered repeater call sign�
Step 2. Gateway “R2” setting
1� Select “R2�”
L To manually enter a call sign, push [QUICK], then
select “Edit�”
2� Select “GW�”
About the RPT2 SELECT screen
NOT USED* For local area calls
GW
To select the gateway call sign from the
repeater list�
Repeater name
To select the repeater that has the
same gateway as the “R1” repeater�
Step 3. Destination “UR” setting
1� Select “UR�”
L To manually enter a call sign, push [QUICK], then
select “Edit�”
2� Select “Gateway CQ�”
3� Select a repeater group where your destination
repeater is listed�
4� Select a destination repeater�
About the YOUR SELECT screen
CQCQCQ
To select “CQCQCQ” to make a non-
call sign specific call�
Gateway CQ*
To select “Gateway CQ” to make a call
using the repeater list�
Your Call Sign
To select the destination “UR” call sign
using the Your Call Sign memory�
RX History
To select the destination “UR” call sign
using RX History�
TX History
To select the destination “UR” call sign
using TX History�
* Not displayed in the Simplex mode�
To Next Page
Loading...
