Icom ID-52A

6
GPS OPERATION (ADVANCED)
6-24
GPS Memory
D Adding a GPS Memory (Continued)
7. Entering the GPS Memory altitude
1� Select “ALTITUDE�”
2� Rotate [DIAL] to select plus or minus�
3� Push D-pad() to move the cursor�
4� Rotate [DIAL] to enter the altitude�
L Set between –32808 and +32808 feet�
5� Repeat steps 3 and 4 to enter the altitude�
6� After entering, push [ENT]�
8. Selecting a GPS Memory group
1� Select “GROUP�”
2� Select the group between (No Group) and A ~ Z�
L You can save up to 300 Memories in each group�
9. Writing the GPS Memory
1� Select “<<Add Write>>�”
• The confirmation dialog is displayed�
L If you edit a previously added GPS Memory, select
“<<Overwrite>>�”
2� Select “YES�”
• The data is added to the GPS memory, and then the
selected GPS Memory group screen is displayed�
L To exit the MENU screen, push [MENU]�
TIP:
To view the entered content:
Select the GPS Memory channel� Rotate [DIAL] to
check the whole content�
To cancel the entered data:
While entering or editing the GPS Memory, push [CLR]
to display the confirmation dialog, as shown below�
Select “YES” to cancel entering, and the display
returns to the GPS Memory group screen�