6
GPS OPERATION (ADVANCED)
6-44
GPS items
Alarm Area (RX/Memory) (Default: Both)
[MENU] > GPS > GPS Alarm >
Alarm Area (RX/Memory)
Selects the GPS active alarm range�
When a target enters the active alarm range, the GPS
Alarm sounds, and the GPS alarm icon blinks�
L When “Alarm Select” is set to “RX” or “Memory,” this
setting is enabled� (p� 6-43)
• Limited: The transceiver sounds 3 beeps, and
the GPS Alarm icon blinks when the
target enters the 500 meters range�
• Extended: The transceiver sounds 3 beeps, and
the GPS Alarm icon blinks when the
target enters the 1-kilometer range�
• Both: The transceiver sounds a beep, and
the GPS Alarm icon blinks when the
target enters the 1-kilometer range
and sounds 3 beeps, and the icon
blinks when it enters the 500 meters
range� When the target exits the
500 meters range but is still in the
1-kilometer range, the icon continues
to blink, but no beeps sound�
Example:
When a target station enters the active alarm range
(500 meters or 1 kilometer range, depending on the
setting), the GPS Alarm sounds, and the GPS Alarm
icon blinks�
Target
station
Sounds 3 beeps�Sounds a beep�
Limited range
approximately 500 m, 547 Y
Extended range
approximately 1 km, 1094 Y
Your location
N
GPS Logger (Default: ON)
[MENU] > GPS > GPS Logger
Turns the GPS Logger function ON or OFF�
This function logs the position, altitude, course, speed,
and number of satellites being used�
• OFF: Turns OFF the function�
• ON: The transceiver automatically logs GPS data�
Once this function is turned ON, the GPS
data will be continuously logged until turning
it OFF, even if the transceiver power is turned
OFF, then ON again�
L This function requires a microSD card (User supplied)�
L When “GPS select” is set to “OFF” or “Manual,” this
function does not save the log�
TIP: The log data is saved on the microSD card� The
file name is automatically created, as shown below:
• Log start date and time: 1st November 2021 15:30:00
• Filename: 20211101_153000�csv
Record Interval (Default: 10sec)
[MENU] > GPS > GPS Logger > Record Interval
Sets the GPS Logger function record interval to 1, 5,
10, 30 seconds, or 1, 5, or 10 minutes�
Record Sentence
(Default:
✔
RMC/
✔
GGA/
✔
VTG/
✔
GSA)
[MENU] > GPS > GPS Logger > Record Sentence
Sets the GPS Logger function record sentence to
RMC, GGA, VTG, or GSA�
• Displays “ ” when the sentence is set�
NOTE: Select at least one sentence, otherwise an
error beep will sound�
<<GPS Logger Only>>
[MENU] > GPS > GPS Logger >
<<GPS Logger Only>>
You can turn ON the GPS Logger Only mode�
Only the GPS Logger is functioning in this mode, and
the transceiver does not transmit or receive it�
L Information
• BE SURE to insert a microSD card�
• Set “GPS Select” to “ON�” (p� 6-30)
• To cancel the mode, restart the transceiver�
To Next Page
Loading...
