12
SET MODE
12-6
Scan
Program Link
[MENU] > SET > Scan > Program Link
Sets the link function for two or more Program Scan
Edge ranges to be sequentially scanned during
a Program Link Scan� The link function scans all
frequencies in the scan range�
Default settings of the Program Link:
L The default setting may differ, depending on the
transceiver version�
L When only one Program Scan Edge range is entered, or
there is no Programmed Scan Edge is left, “Add” is not
displayed after pushing [QUICK]�
DUP Check During MR Scan (Default: OFF)
[MENU] > SET > Scan > DUP Check During MR Scan
During a Memory scan, selects whether or not to scan
the offset frequency if Duplex is set on the channel�
• OFF: The offset frequency is not scanned�
• ON: The offset frequency is also scanned�
...
Program Link 0
1：
9：
Edit Name
01
144.000−148.000
Program Link number (0 to 9)
Blank
Delete
02： 430.000−450.000
Delete
To Next Page
Loading...
