IEMCA BOSS 545 E - 6 - USE AND OPERATION; 6.1 CONTROL DESCRIPTION; 6.2 KEYBOARD CONTROL DESCRIPTION; 6.4 BARS TO BE MACHINED - FEATURES AND PREPARATION

6 - USE AND OPERATION BOSS 332/545/552 HD
EN
6 - Pag. 1 / 24
INDEX
6.1 CONTROL DESCRIPTION..........................................................................................2
6.2 KEYBOARD CONTROL DESCRIPTION.........................................................................4
6.3 LIGHT INDICATOR - SIGNAL DESCRIPTION ..............................................................8
6.4 BARS TO BE MACHINED - FEATURES AND PREPARATION..........................................9
6.4.1 BAR STRAIGHTNESS - Measurement.......................................................................11
6.5 BAR FEEDER SET-UP AND AUTOMATIC CYCLE START..............................................13
6.5.1 Bar magazine - Filling.............................................................................................14
6.5.2 Lubrication oil - Flow adjustment ............................................................................15
6.5.3 Automatic cycle start..............................................................................................16
6.5.4 Guide channel opening/closing procedure................................................................17
6.5.5 Mode of performing a cycle in the STEP BY STEP function........................................18
6.6 BAR FEEDER STOP.................................................................................................18
6.7 AUTOMATIC CYCLE START AFTER MANUAL CYCLE OPERATIONS .............................20
6.8 AUTOMATIC CYCLE START - RESUMING WORK AFTER POWER-OFF.........................20
6.9 MACHINING CHANGE - QUICK GUIDE ..............................................................22
6.9.1 Machining type change with guide channel change ..................................................22
6.9.2 Machining type change without guide channel change..............................................23