4 - HANDLING AND INSTALLATION BOSS 332/545/552 HD
EN
4 - Pag. 13 / 32
ALIGNMENT
• Insert the (supplied) crank in the intermediate
drive shaft and move the bar pusher to its
backwards limit stop.
• Move the crank to the guide channel opening
screw shaft and open the upper guides.
To obtain alignment lead a (ø 1 mm) nylon
thread between the lathe collet and the bar
feeder rear plate, then proceed as follows:
• place a drilled bush "A" in the lathe collet;
• stretch out the thread to the hole in the rear
plate;
To Next Page
Loading...
