4 - HANDLING AND INSTALLATION BOSS 332/545/552 HD
EN
4 - Pag. 15 / 32
4.4.6 Bar feeder fastening
GROUND FASTENING
• Drill the floor and fix the backing plates with
expansion plugs.
• Fix the bar feeder to the plates through the tie
rods "A" and lock with nuts "B".
• Check the levelling and alignment once more.
• Remove all the equipment used for the levelling
and alignment phases and restore the initial bar
feeder conditions.
FASTENING TO THE LATHE
Wherever possible, the bar feeder should be fixed
to the lathe with a suitable coupling unit according
to lathe brand and type. The figure shows a general
example of fixing; contact IEMCA service
department for more information.
To Next Page
Loading...
