Parameter List
‑30‑
Parame
ter
Address Name Value Range Default Unit Change
Method
Page
F5‑13 0xF50D AO2 gain ‑10.00 to +10.00 1 ‑ In real time "
F5‑13
"
on
page 205
F5‑17 0xF511 Extension card
relay output delay
0.0s to 3600.0s 0 s In real time "
F5‑17
"
on
page 205
F5‑18 0xF512 Control board
relay 1 output
delay
0.0s to 3600.0s 0 s In real time "
F5‑18
"
on
page 205
F5‑19 0xF513 Control board
relay 2 output
delay
0.0s to 3600.0s 0 s In real time "
F5‑19
"
on
page 206
F5‑20 0xF514 DO1 output delay 0.0s to 3600.0s 0 s In real time "
F5‑20
"
on
page 206
F5‑21 0xF515 Extension card
DO2 output delay
0.0s to 3600.0s 0 s In real time "
F5‑21
"
on
page 206
F5‑22 0xF516 DO active mode
selection
Ones (position): Expansion
card relay
0: Positive logic
1: Negative logic
Tens (position): Control board
relay 1
0: Positive logic
1: Negative logic
Hundreds (position): Control
board relay 2
0: Positive logic
1: Negative logic
0 ‑ In real time "
F5‑22
"
on
page 207
Contin
ued
Contin
ued
Continued Thousands (position): Control
board DO1
0: Positive logic
1: Negative logic
Ten thousands (position):
Expansion card DO2
0: Positive logic
1: Negative logic
Contin
ued
Contin
ued
Continued Continued
F6‑00 0xF600 Startup mode 0: Direct startup
1: Flying start
2: Vector pre‑excitation
startup (asynchronous motor)
0 ‑ In real time "
F6‑00
"
on
page 207
F6‑01 0xF601 Flying start mode 0: From stop frequency
1: From 50 Hz
2: From the maximum
frequency
3: Reserved
0 ‑ At stop "
F6‑01
"
on
page 208
F6‑02 0xF602 Speed of speed
tracking
1 to 100 20 ‑ In real time "
F6‑02
"
on
page 209
To Next Page
Loading...
