Protecting Local Disks
Intel
®
Entry Storage System SS4000-E User Guide 93
5. If Microsoft* iSCSI Initiator 2.0 is already installed, go to the next step. If this
component is not currently installed, the following prompt displays:
Click OK to go to the Microsoft website and then click OK to cancel the installation
of Intel
®
Client Backup and Recovery.
On the Microsoft website, click iSCSI Software Initiator v2.0, and follow the
instructions in “Installing the Microsoft iSCSI Initiator*” on page 91.
Before you can install Intel
®
Client Backup and Recovery, you must install the
Microsoft iSCSI Initiator 2.0.
When you finish installing the iSCSI initiator, re-start the installation of Intel
®
Client
Backup and Recovery.
6. If Microsoft .NET Framework 1.1 is already installed, go to step 9. If this component
is not currently installed, the following prompt displays:
Click Yes to install this component. You cannot install Intel
®
Client Backup and
Recovery without first installing Microsoft .NET Framework 1.1.
When you click Ye s, the setup utility for Microsoft .NET Framework 1.1 starts:
7. If you agree to the terms of the license agreement, select I agree and then click
Install.
It might take some time to copy and configure the associated files.
Note: The remaining time might be reported as 0 and might display that no progress
is occurring. However, configuration is occurring in the background.
8. When a message displays, indicating that the installation of Microsoft .NET
Framework 1.1 is complete, click OK.
After you click OK, the Intelligent Management Agent is installed automatically if it
is not already installed, and the welcome page for installing Intel
®
Client Backup and
Recovery displays.
9. On the welcome page, click Next. The license agreement displays.
10. If you agree to the terms of the license agreement, select I accept the terms of the
license agreement and then click Next.
To Next Page
Loading...
Need help?
General