Protecting Local Disks
Intel
®
Entry Storage System SS4000-E User Guide 101
If no storage systems are automatically discovered, or if you want to back up your
disk to a different storage system, enter the name or IP address of the desired storage
system in the Storage system name or IP address text box.
Click OK.
Note: If an authentication error occurs, make sure the name or IP address of the
storage system is correct, and that your computer is connected to the network.
4. From the Backup locations list, select the storage system to use for backups of this
disk or partition. The first backup location in the list is selected by default.
If you want to scan the network for new storage systems, or add a new one manually,
click Add and repeat step 3.
If you want to remove a storage system that is not valid or that you no longer want to
use, select the storage system from the Backup locations list, click Remove, and then
click Yes to confirm the removal. You can remove a storage system only if it is not
being used to protect another disk.
Once you select the desired backup location, click Next and go to step 6.
To Next Page
Loading...
Need help?
General