Intermec EasyCoder PM4i User Manual

Chapter 9 — Options
EasyCoder PM4i Printer User’s Guide (Fingerprint Version) 85
Integral Liner Takeup Unit
The integral liner takeup unit is an optional device for peel-off
(self-strip) operation, which means that the labels are separated
from a liner (backing paper) after printing and the liner is wound
up on an internal hub. The unit also includes a guide shaft. Peel-
off cannot be combined with an internal fanfold guide. For more
information, see Chapter 4, “Media Load.”
Paper Cutter
The paper cutter is designed to cut off continuous paper-based
stock or liner between labels. The cut-off labels, tickets, or tags
can be collected on an optional tray.The paper cutter can be
controlled using the instructions CUT, CUT ON, and CUT
OFF in Intermec Fingerprint and the Direct Protocol. For more
information, see Chapter 4, “Media Load.”
Media Supply Hub
The rotating media supply hub is designed to fit media roll cores
with an internal diameter of 38-40 mm (1.5 in).
Paper Sensor
The paper sensor is fitted inside a plastic cover in the center
section below the media supply hub. It can only be used with a
rotating media supply hub and detects when the remaining
media supply has reached a preset minimum diameter, as
specified in the Setup Mode.
Tear-Off Bar
The adjustable tear-off bar is particularly useful when delicate
media is used in peel-off operation.
Media Roll Retainer
The retainer is intended to keep large media rolls in place when
using a rotating media supply hub. It restricts the maximum
media width to 100 mm (3.9 in). Installed by the operator.

Intermec EasyCoder PM4i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Product color	Silver
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Media thickness	2.5/8.7 mm
Maximum label width	114.3 mm
Maximum label length	4 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements	90 - 265 VAC, 45 - 65Hz
Power consumption (standby)	15 W
Power consumption (printing)	125 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth	543 mm
Width	298 mm
Height	261 mm
Weight	13500 g