Intermec EasyCoder PM4i User Manual

Chapter 11 — Maintenance
106 EasyCoder PM4i Printer User’s Guide (Fingerprint Version)
To clean the media guide
1 Loosen the screw on the edge guide.
2 Pull both the upper LSS guide and the edge guide straight
out.
3 After cleaning, put back the parts in reverse order making sure
that the LSS shafts fits into the holder on the upper LSS
guide.
Printhead Replacement
The printhead is subject to wear both from the direct thermal
media or ribbon and from the rapid heating and cooling process
during printing. Thus, the printhead will require periodic
replacement.
Time between printhead replacements depends on the print
images, the type of direct thermal media or ribbon in use, the
amount of energy to the printhead, the print speed, the ambient
temperature, and several other factors.
Clean here
Print mechanism
(lower part only)
Upper LSS guide
Upper label
stop sensor
Shaft
Holder
Edge
guide
While replacing the printhead, the power must be off. The
firmware will not detect the new printhead resistance until the
printer has been restarted.

Intermec EasyCoder PM4i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Product color	Silver
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Media thickness	2.5/8.7 mm
Maximum label width	114.3 mm
Maximum label length	4 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements	90 - 265 VAC, 45 - 65Hz
Power consumption (standby)	15 W
Power consumption (printing)	125 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth	543 mm
Width	298 mm
Height	261 mm
Weight	13500 g