Chapter 2 — Installation
EasyCoder PM4i Printer User’s Guide (Fingerprint Version) 11
Connections
Power
To connect the power
1 Place the printer on a level surface, near an AC outlet. You
should be able to easily access the printer to load media and to
remove the printout.
2 Check that the printer is switched off.
3 Connect the power cord from the socket on the rear plate to
an electrical outlet (90 to 265 VAC).
Computer
The Easycoder PM4i is fitted with one 9-pin D-style
subminiature (DB9) socket for the RS-232 serial interface port
and one class B connector for the USB interface port (For help,
see “Interfaces” on page 139.).
RS-232 Serial Interface ("uart1:")
Use the serial interface with Intermec LabelShop or the Intermec
InterDriver. Also use it with the Intermec Direct Protocol or the
Intermec Fingerprint programming language because you can
receive error messagesn from your printer. Before you can use the
serial interface, you may need to set up the communication
parameters, such as baud rate, parity, etc. as described in “Setting
Up the Printer” on page 51.
USB Interface ("usb1:")
Use the USB interface with an USB-compatible version of the
Intermec InterDriver for printing. The USB interface is not
suitable for programming because the host cannot receive error
messages from your printer.
Optional Interface and Network Boards("uart2:", "uart3:",
"uart4:", "uart5:", "centronics:", and "net1:")
Several types are available (see “Options” on page 83). Refer to
Chapter 6, Chapter 7, and Appendix C for connection and setup
instructions.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
