Chapter 1 — Introduction
EasyCoder PM4i Printer User’s Guide (Fingerprint Version) 3
A version of EasyCoder PM4i, that supports the Intermec
Programming Language (IPL), is described in a special User’s
Guide.
Safety Summary
Intermec assumes no responsibility regarding the CE Directive if
the printer is handled, modified, or installed in any way other
than that described in Intermec’s manuals.
• Read this manual carefully before connecting the printer.
• Moving parts are exposed when the side doors are open, so
ensure that the doors are closed before you operate the printer.
• Do not open the front/left-hand cover. Dangerous voltage!
• Do not remove the bottom plate. Dangerous voltage!
• Do not put your fingers inside the print mechanism when the
power is on.
• Make sure that the side door cannot unintentionally swing
down when you have your fingers or hands inside the media
compartment. Risk of injury because of the weight of the side
door!
• Place the printer on an even surface which can support its
weight of approximately 13.5 kg (30 pounds) plus supplies.
• Do not spray the printer with water. If you are using a hose to
clean the premises in an industrial environment, remove the
printer or protect it carefully from spray and moisture.
• Carefully read the warning text on the envelope before using a
cleaning card.
Product Identification
The machine label is attached to the printer’s rear plate and
contains information on type, model, and serial number as well
as AC voltage. It also contains various signs of approval.
If you open the electronics cover, you will void the warranty
and may cause damage to the internal components. Opening
the electronics cover exposes the user to shock hazards which
may result in injury or death.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
