Chapter 6 — Setting Up the Printer
52 EasyCoder PM4i Printer User’s Guide (Fingerprint Version)
Description
The setup controls the printer in regard of serial communication,
test and service operations, and specifies which types of media
and ribbon are loaded in the printer.
Check the list below to see if the printer’s default setup matches
your requirements. If not, you will have to change the setup. To
enter the Setup Mode, press the Setup key on the printer’s built-
in keyboard and follow the instructions in “Setup Mode” on
page 69.
The setup may also be changed by Intermec PrintSet,
InterDriver, and LabelShop, or thirdparty application programs.
Setup Mode
•Press the Setup key on the printer’s built-in keyboard to enter
the Setup Mode, or
• select the Setup option in Intermec Shell to enter the Setup
Mode, or
• execute the Intermec Fingerprint SETUP instruction to enter
the Setup Mode, or
• access the Setup Mode via the printer’s home (requires an
optional EasyLAN interface board).
See Chapter 7, “Setup Mode” in this manual and the
EasyLAN documentation.
Intermec Fingerprint
•Use setup strings to change individual setup parameters
remotely from the host, or
•use setup files to create sets of setup parameters remotely
from the host.
See the Intermec Fingerprint Command Reference Manual
(P/N 937-005-XXX).