Intermec EasyCoder PM4i User Manual

Chapter 8 — Intermec Shell Startup Program
EasyCoder PM4i Printer User’s Guide (Fingerprint Version) 75
firmware from a Compact-Flash card, or upgrading the
printer’s fi rmware from a file in a PC)
• Reboot (restarting the printer)
Starting with Intermec Shell
A few seconds after you have switched on the power to the
printer and the initialization is completed, the countdown menu
of the Intermec Shell program will be displayed:
ENTER=SHELL
5 sec. v. 8.2
Now you have 5 seconds to enter Intermec Shell by pressing
Enter.
The lower line tells you how much time you have left. Should the
time run out before you have taken any action, the last selected
application in Intermec Shell will be opened. If you use the same
application all the time, you will only need to switch on the
power, once the application has been selected.
If no other application has yet been selected, the current version
of Intermec Fingerprint will be opened with "auto" selected as std
I/O channel (see Intermec Fingerprint manuals). When the
countdown is completed, you will see these lines in the display:
Fingerprint
8.30
If you want to select another application, just cycle the power and
enter Intermec Shell before the countdown is completed.
When you enter the Intermec Shell from the countdown menus,
the Select Application menu will be displayed:
SHELL
SEL. APPLICATION
In this menu, you can choose between two options:
Note: Intermec Shell is factory-installed in the printer’s
permanent memory (device "/rom"). If you insert a memory card
with another startup file before you switch on the printer, or if
there is a startup file stored in the printer’s permanent memory
(device "/c"), this startup file will be used instead of Intermec
Shell (see Chapter 3, “Startup Files”).

Intermec EasyCoder PM4i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Product color	Silver
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Media thickness	2.5/8.7 mm
Maximum label width	114.3 mm
Maximum label length	4 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements	90 - 265 VAC, 45 - 65Hz
Power consumption (standby)	15 W
Power consumption (printing)	125 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth	543 mm
Width	298 mm
Height	261 mm
Weight	13500 g