Chapter 6 — Setting Up the Printer
EasyCoder PM4i Printer User’s Guide (Fingerprint Version) 57
When enough data have been processed so the receive buffer is
filled only to 50%, the printer sends an XON character and the
host resumes transmitting data. The same principles apply to
XON/XOFF sent by the host, even if the percentage figure may
differ. By default, XON/XOFF is disabled for data in both
directions.
New Line
Selects the character(s) transmitted from the printer to specify the
switching to a new line. There are three options:
• CR/LF ASCII 13 + 10 dec. (default)
• LF ASCII 10 dec.
• CR ASCII 13 dec.
Receive Buffer
The receive buffer stores the input data before processing.
Default size is 1024 bytes.
Transmit Buffer
The transmit buffer stores the output data to be transmitted
before transmission. Default size is 1024 bytes
Feedadjust
The Feedadjust part of the Setup Mode controls how much of
the media is fed out or pulled back before and/or after the actual
printing. These settings are global and will be effected regardless
of which program is run.
Start Adjust
The Start Adjust value is given as a positive or negative number of
dots. Default value is 0, which places the origin a certain distance
back from the forward edge of the copy.
• A positive start adjustment means that the specified length of
media will be fed out before the printing starts. Thus, the
origin is moved further back from the forward edge of the
copy.
Note: The firmware uses the front edges of labels w. gaps, the
ends of detection slots, and the forward edges of black marks for
detection, all seen in relation to the feed direction.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
