Chapter 8 — Intermec Shell Startup Program
78 EasyCoder PM4i Printer User’s Guide (Fingerprint Version)
• Update CompactFlash card allows the printer to be used as a
CompactFlash card programming device. Any files can be
downloaded from a PC to a standard CompactFlash card
inserted in the memory card slot in the printer’s rear plate.
A typical application is to create a firmware upgrade card from
an upgrade file stored in a PC. You can use the card to
upgrade the firmware in several printers simply by moving the
card from printer to printer. Just insert the card, switch on the
power, and wait from the prompts to appear in the printer’s
display window.
• Update firmware is used to directly upgrade the firmware of a
specific printer from a new firmware version stored as a file in
a PC. If the printer is equipped with an EasyLAN Ethernet or
Wireless board, the user must have access rights to upgrade
the firmware, see the EasyLAN User’s Guide.
Firmware upgrade files can be found on www.intermec.com or
be obtained from your local Intermec distributor.
Reboot
Corresponds to cycling the power to the printer. To exit Intermec
Shell without having selected any application, select Reboot.
Then wait for the 5 seconds countdown to finish, and the last
selected application will be opened.
If the CompactFlash card or upgrade file contains an earlier
firmware version than the one in the printer, the printer’s
firmware will be downgraded without warning.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
