Chapter 7 — Setup Mode
70 EasyCoder PM4i Printer User’s Guide (Fingerprint Version)
Entering Setup Mode at Installation
The method of entering the Setup Mode depends on which
startup files are stored in the printer’s memory, a subject that was
more thoroughly discussed in Chapter 3, “Starting Up.”
EasyCoder PM4i with Intermec Shell
• Switch on the power.
• When the display shows the message
“Enter=Shell;
x sec...”
, press Enter.
•Press Setup (this facility can be used anywhere within
Intermec Shell).
• Set up the printer as described in this chapter.
• Return to Intermec Shell by pressing Setup.
Easycoder PM4i With A Custom-made Application Program
• Normally, there is no need to enter the Setup Mode for
custom-made application programs. Necessary provisions for
changing the setup, manually or automatically, should be
provided by the program.
Navigating in Setup Mode
Enter the Setup Mode by pressing the Setup key on the printer’s
front panel. While going through the setup procedure, you are
guided by texts in the printer’s display. You can navigate between
setup menus, acknowledge displayed values, select or enter new
values, etc. by using the keys on the printer’s keyboard.
Note: An external keyboard cannot be used inside the Setup
Mode.
To Next Page
Loading...
