Intermec EasyCoder PM4i User Manual

Chapter 10 — Troubleshooting
EasyCoder PM4i Printer User’s Guide (Fingerprint Version) 91
Cutter error3 Blink 1703
Cutter open 1704
Lss too high Blink 1007
Lss too low Blink 1008
Testfeed not done Blink 1606
No RFID support
installed
Blink 1320
No tag found
Blink 1321
Pause Mode
entered
Blink
Setup Mode
entered
Blink Includes interactive setup from
Fingerprint/Direct Protocol
IP link error
Blink See note 1, 2, and 3
IP configuration
error
Blink See note 1, 3, and 4
Generic DP error
Blink See note 5
Press any key to
continue
Off See note 6
Application load
error
Blink See note 7
RtW blink by
application
Blink Set by Fingerprint instruction
SYSHEALTH
RtW off by
application
Off Set by Fingerprint instruction
SYSHEALTH
Application break
Off See note 8
Printhead not found
Off
Rebooted
Off
Inizializing
Off Set at startup until operational
Printer crash
Off See note 3 and 9
Printer turned off Off
Maintenance Off Set when upgrading
Power supply Over
temperature
Off 1718
Printhead too hot Off 1088 See note 10
Display Messages and LED Indications (continued)
Error/Event RtW
Error
No. Comment

Intermec EasyCoder PM4i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Product color	Silver
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Media thickness	2.5/8.7 mm
Maximum label width	114.3 mm
Maximum label length	4 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements	90 - 265 VAC, 45 - 65Hz
Power consumption (standby)	15 W
Power consumption (printing)	125 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth	543 mm
Width	298 mm
Height	261 mm
Weight	13500 g