Chapter 6 — Setting Up the Printer
EasyCoder PM4i Printer User’s Guide (Fingerprint Version) 67
Bar Codes #2
Setup Info
Hardware Info
UART1 9600-8-N-1
RTS/CTS DISABLE
ENQ/ACK DISABLE
XON/XOFF
DATA TO HOST DISABLE
DATA FROM HOST DISABLE
NEW LINE CR/LF
REC BUF 300
TRANS BUF 300
PRINT CONFIG
STARTADJ 0
STOPADJ 0
XSTART 24
WIDTH 808
LENGTH 1200
MEDIA TYPE LABEL (w GAPS)
PAPER TYPE TRANSFER
LABEL CONSTANT 85
LABEL FACTOR 40
RIBBON CONSTANT 90
RIBBON FACTOR 25
LABEL OFFSET 0
RIBBON SENSOR 14
LOW DIAMETER 36
CONTRAST +0%
TESTFEED 170 202 2 5
HEAD RESIST 702
PRINT SPEED 100
LTS VALUE 8
IP SELECTION DHCP+BOOTP
IP ADDRESS 192.168.235.104
NETMASK 255.255.254.0
DEFAULT ROUTER 192.168.234.1
NAMESERVER 192.169.234.20
FIRMWARE
Fingerprint (version number)
MCS (number, date, time, and processor family)
Hardware
1-971631-50 / PSU / 1.0 / 0031-000000
1-971633-25 / Console / 1.1 / 0033-000000
1-959032-01 / TPH / 0.0 / 0001Z-00085
1-971630-50 / CPU / 1.1 / 0030-000016
1-971641-50 / IEEE1284-1 / 1.1 / 0146-000010
EasyLAN / 00104017B872
Model PM4i
Hardware version 4.0 (CLIC version 1)
Ram 8192 (k)
Flash 0+4096 (k)
CompactFlash 0 (k)
c: 4023296 bytes free
tmp: 3702056 bytes free
Odometer 0 (m)
To Next Page
Loading...
