Intermec EasyCoder PX6i Service Manual

0RESS
SIDEWAYS
120 EasyCoder PX4i and PX6i Service Manual
Chapter 11 — Paper Cutter
• Fit the cutter unit to the vacant hinges. Make sure that the locking plate
snaps into the groove of the right-hand hinge and that the angled plate
at the bottom of the cutter is inserted under the printer’s bottom plate.
• Connect the cable from the cutter unit to the DIN socket on the print-
er’s front.
• Tilt the cutter unit upwards until it locks into place. If the cutter does
not lock properly, the hinges of the cutter unit may need to be adjusted
using a #T10 Torx screwdriver.
• Connect the power cord and switch on power. The cutter will perform
an idle cycle in order to occupy its home position.
• Switch off the power. Tilt down the cutter and route the media through
the cutter unit between the guide plates (see illustration above). Then
tilt the cutter up again and lock it in closed position. Check that the
printhead is lowered and switch on the power. Now the printer is ready
for operation.
DIN socket

Intermec EasyCoder PX6i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Product color	Silver
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Media thickness	2.4/10 mm
Maximum label width	170 mm
Maximum label length	4 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements	90 - 265 VAC, 45 - 65Hz
Power consumption (standby)	20 W
Power consumption (printing)	125 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	482 mm
Width	238 mm
Height	335 mm
Weight	14800 g