iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
216
Table 3.3.7.2-3 STATION GROUP ATTRIBUTES — RING GROUPS (PGM 191)
RING 405 ANNC1 TMR(1s)
(000 – 999) : 015
If all stations in the group are busy when a
call is offered, the call may continue to wait
(queue) for an available station.
If the queue period exceeds this
1stAnnouncement Timer, the call may be
sent to a VSF announcement.
If the timer is set to 000, the call will receive
the first announcement, in full, prior to the
hunt process (guaranteed announcement).
RING 405 ANNC 2 TMR(1s)
(000 – 999) : 000
After the 1stannouncement, a 2ndANNC
TMR is activated. At expiration, if the call
remains queued to the group, the call is
sent to the assigned 2nd VSF
announcement.
RING 405 ANNC1 LOC
VSF ANNC .. ( 01–70 )
Each Ring Group can be assigned an
announcement, which is played if the call
remains queued beyond the ANNC 1 TMR
duration.The announcement location is a
VSF ANNC1 number. An entry of 00
indicates no announcement. Including ‘#’ at
the end of an entry instructs the system to
disconnect after the announcement.
RING 405 ANNC2 LOC
VSF ANNC .. ( 01–70 )
The Ring Group can be assigned a
2ndannouncement, which is played if the
call remains queued beyond the ANNC 2
TMR duration.
The announcement location is a VSF
ANNC2 number. An entry of 00 indicates
no announcement. Including ‘#’ at the end
of an entry instructs the system to
disconnect after the announcement.
RING 405 ANNC2 RPT TMR
(000 – 999) : 000
The 2ndannouncement can be repeated to
calls that remain in the queue at
Announcement 2 Repeat Timer intervals.
Note repeating must be “ON” under button
6 below.
RING 405 ANNC2 RPT
(1: ON / 0: OFF): OFF
After the 2ndannouncement, if the call
remains queued to the group, the 2
nd
VSF
announcement can be repeated at the
Announcement Repeat Timer interval.
To Next Page
Loading...
