EasyManuals Logo

ITech IT8200 Series Programming Guide

ITech IT8200 Series
137 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #101 background imageLoading...
Page #101 background image
ARB Subsystem
Copyright © ITECH Electronic Co., Ltd. 81
Chapter17 ARB Subsystem
LIST:STATe?
This command is used to query the running status of list, IDLE: stopped, WTG:
waiting for trigger, ACTive: running
Syntax:
LIST:STATe?
Example
LIST:STAT?
LIST:REPeat <NR1>
This command is used to set and query the number of cycles run by list.
Syntax:
LIST:REPeat <NR1>
Arguments
<NR1>
MINimum|MAXimum|DEFault
*RST
0
Query syntax:
LIST:REPeat?
Returns:
<NR1>
Example
LIST:REP 10
LIST:TERMinate <CPD>
This command is used to set and query the way to end the list operation. There
are three ways to end:
NORMal: after the list runs, it will automatically return to normal.
LAST: keep the output of the last step after the list runs.
OFF: turn off the output after the list operation is over and still in the list mode.

Table of Contents

Other manuals for ITech IT8200 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ITech IT8200 Series and is the answer not in the manual?

ITech IT8200 Series Specifications

General IconGeneral
BrandITech
ModelIT8200 Series
CategoryMeasuring Instruments
LanguageEnglish