ITech IT8200 Series

SURGesag Subsystem
Copyright © ITECH Electronic Co., Ltd. 96
Example
SURGesag:VALue:PERCent 10 //Set the drop percentage to 10%
SURGesag:VALue:PERCent?
SURGesag:VALue:SETTing <NRf+>
This command is used to set and query the drop value of the trap wave.
<NRf+> drop set value
Syntax:
SURGesag:VALue:SETTing <NRf+>
Arguments
<NRf+>
*RST
0
Query syntax:
SURGesag:VALue:SETTing? [MAXimum| MINimum]
Returns:
<NRf+>
Example
SURGesag:VALue:SETT 20 //Set the drop value to 20V
SURGesag:VALue:SETT? //Query the set value of the drop value
SURGesag:VALue:SETT? MAX //Query the maximum value of the drop set
value.
SURGesag:CHAN:ENABle <A|B|C|AB|AC|BC|ABC>
This command is used to set and query the phase of the trap dip, and is only
available in three-phase mode.
Syntax:
SURGesag:CHAN:ENABle <A|B|C|AB|AC|BC|ABC>
Arguments
<A|B|C|AB|AC|BC|ABC>
Query syntax:
SURGesag:CHAN:ENABle?
Returns:
<NRf+>