ITech IT8200 Series

Input Subsystem
Copyright © ITECH Electronic Co., Ltd. 78
Query syntax:
INPut:ON:PHASe:LEVel?
Returns:
MINimum|MAXimum
Example
INPut:ON:PHASe:LEVel 60
INPut:OFF:PHASe:MODE <CPD>
The command sets the mode of phase control when the instrument input is turned
off.
PHASe: The load stop input with the set phase angle
IMMediate: the load stop input with 0 phase angle.
Syntax:
INPut:OFF:PHASe:MODE <CPD>
Arguments
PHASe|IMMediate
Query syntax:
INPut:OFF:PHASe:MODE?
Returns:
PHASe|IMMediate
Example
INPut:OFF:PHASe:MODE IMM
INPut:OFF:PHASe:LEVel <NRf+>
This command is used to set the phase angle value when the instrument input is
turned off.
Syntax:
INPut:OFF:PHASe:LEVel <NRf+>
Arguments
MINimum|MAXimum|DEFault
Query syntax:
INPut:OFF:PHASe:LEVel?